| Inspection Type |
Referral
|
| Scope |
Partial
|
| Safety/Health |
Safety
|
| Close Conference |
2018-03-06
|
| Case Closed |
2019-09-26
|
Related Activity
| Type |
Referral |
| Activity Nr |
1308489 |
| Safety |
Yes |
|
Violation Items
| Citation ID |
01001A |
| Citaton Type |
Serious |
| Standard Cited |
19260501 B10 |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-05-04 |
| Current Penalty |
1200.0 |
| Initial Penalty |
2217.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
3 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.501(b)(10): Each employee engaged in roofing activities on low-slope roofs, with unprotected sides and edges 6 feet (1.8 m) or more above lower levels, was not protected from falling by guardrail systems, safety net systems, personal fall arrest systems: (a) On or about February 2, 2018, and at times prior thereto, employees involved in roofing activities on a 3 in12 pitch roof and exposed to an approximate 14 foot fall hazard. Note: Abatement certification IS required for this item. |
|
| Citation ID |
01001B |
| Citaton Type |
Serious |
| Standard Cited |
19260503 A01 |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-05-04 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
2 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee exposed to fall hazards to enable them to recognize the hazards of falling and the procedures to follow in order to minimize them. (a) On or about February 2, 2018, and at times prior thereto, employees were not provided with a training program that provided them with the ability to recognize the hazards associated with fall hazards and/or what procedures to follow to minimize the risk. Note: Abatement certification IS required for this item. |
|
| Citation ID |
01002 |
| Citaton Type |
Serious |
| Standard Cited |
19261053 B01 |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-05-04 |
| Current Penalty |
1200.0 |
| Initial Penalty |
2217.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
3 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed: (a) On or about February 2, 2018, and at times prior thereto, the employer's ladder extended only inches above the roof landing. Note: Abatement certification IS required for this item. |
|
|
| Inspection Type |
Planned
|
| Scope |
Partial
|
| Safety/Health |
Safety
|
| Close Conference |
2018-03-06
|
| Emphasis |
N: DUSTEXPL, P: DUSTEXPL
|
| Case Closed |
2019-09-26
|
Violation Items
| Citation ID |
01001A |
| Citaton Type |
Serious |
| Standard Cited |
5A0001 |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-05-04 |
| Current Penalty |
0.0 |
| Initial Penalty |
2772.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
2 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which was free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were allowed to operate the Hyster without a seatbelt. (a) On or about March 6, 2018, and at times prior thereto, employees utilized a Hyster at the Sawmill that was not equipped with a seatbelt. Note: Abatement certification IS required for this item. |
|
| Citation ID |
01001B |
| Citaton Type |
Serious |
| Standard Cited |
19100178 A06 |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-05-04 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
2 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.178(a)(6): Nameplates or markings for powered industrial trucks were not in place: (a) On or about March 6, 2018, and at times prior thereto, the Hyster was not equipped with identification plate. Note: Abatement certification IS required for this item. |
|
| Citation ID |
01001C |
| Citaton Type |
Other |
| Standard Cited |
19100178 L02 II |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-07-01 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
2 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.178(l)(2)(ii): The employer did not ensure that each operator had successfully completed the training consisting of a combination of formal instruction (e.g., lecture, discussion, interactive computer learning, video tape, written material), practical training (demonstrations performed by the trainer and practical exercises performed by the trainee), and evaluation of the operator's performance in the workplace: (a) On or about March 6, 2018, and at times prior thereto, the employer did not train employees in accordance to the regulatory requirements. Note: Abatement certification IS required for this item. |
|
| Citation ID |
01001D |
| Citaton Type |
Other |
| Standard Cited |
19100178 P01 |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-07-01 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
2 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.178(p)(1): Powered industrial truck(s) with a defect(s) or in any way deemed unsafe had not been withdrawn from service until restored to safe operating condition(s): (a) On or about March 6, 2018, and at times prior thereto, the Hyster had a cracked windshield and was not removed from service. Note: Abatement certification IS required for this item. |
|
| Citation ID |
01002A |
| Citaton Type |
Serious |
| Standard Cited |
19100022 A01 |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-05-04 |
| Current Penalty |
0.0 |
| Initial Penalty |
1663.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
3 |
| Gravity |
1 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.22(a)(1): The work area was not kept in a clean and orderly manner. (a) On or about March 6, 2018, and at times prior thereto, the Sawmill was littered with broken machinery , tools that no longer in use; excess wood debris was not removed and discarded creating slip, trip, laceration and/or fall hazards. Note: Abatement certification IS required for this item. |
|
| Citation ID |
01002B |
| Citaton Type |
Serious |
| Standard Cited |
19100022 D01 |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-05-04 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
1 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.22(d)(1): Walking-working surfaces were not maintained in a safe condition. (a) On or about March 6, 2018, and at times prior thereto, the working surface where employee stands to sharpen the circular head saw blade was missing wood flooring planks. Note: Abatement certification IS required this item. |
|
| Citation ID |
01003 |
| Citaton Type |
Serious |
| Standard Cited |
19100147 C04 I |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-07-01 |
| Current Penalty |
1800.0 |
| Initial Penalty |
3880.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
10 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section. (a) On or about March 6, 2018, and at times prior thereto, procedures were not developed and/or utilized and while an an employee was sharpening a 60 inch circular head saw blade and it was inadvertently turned on. Note: Abatement certification and documentation ARE required for this item. |
|
| Citation ID |
02001 |
| Citaton Type |
Other |
| Standard Cited |
19040039 A02 |
| Issuance Date |
2018-04-10 |
| Abatement Due Date |
2018-07-01 |
| Current Penalty |
0.0 |
| Initial Penalty |
2772.0 |
| Final Order |
2018-05-10 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1904.39(a)(2): The employer did not report the in-patient hospitalization of one or more employees to OSHA within twenty-four (24) hours. (a) On January 4, 2018, an employee was sharpening a 60 inch circular head saw blade when it was inadvertently turned on and he was life-flighted and admitted into Saint Alphonsus Hospital. Note: Abatement certification IS NOT required this item. |
|
|
